The DSMC2® V-Lock I/O Expander offers a variety of Input/Output connections, as well as an industry standard V-Lock mount to power your DSMC2 camera using RED BRICK® batteries. Constructed from lightweight and durable magnesium, this expander module mounts directly to the rear of the camera BRAIN® and offers connections for the following:
• DC Power input (DC-IN)
• HDMI 1.2 output (Type A socket)
• 3G-SDI output (HD-SDI, 75 Ω BNC)
• CTRL & SYNC ports (2x 00B LEMO 4-Pin, Timecode and Genlock support)
• AUX Power output (P-Tap 2-Pin female)
• USB Power output (Type A, 5 V at 1.5 A for powering HDMI transmitters or small mobile devices)
• Stereo Headphone output (3.5 mm jack)
• Stereo Analog input (3.5 mm jack)
The DSMC2 V-Lock I/O Expander also features a selector switch that enables the BRAIN to automatically boot when power is provided via the DC-IN connector on the expander. This feature allows you to use a connected DC input supply to turn the BRAIN on and off when the camera is mounted in remote or difficult to maneuver locations.
This expander is an ideal solution for a wide variety of production environments—from low-profile run-and-gun situations to studio shoots that require mobility.
NOTE: The DSMC2 Top Handle is NOT fully compatible with the DSMC2 Base I/O V-Lock Expander, as the top handle will interfere with most tall batteries when one is attached to the expander module.
NOTE: Only one (1) expander module can be used at a time.
DSMC2 V-Lock I/O Expander
|DIMENSIONS||Height: 4.57 in. (116.0 mm)|
Width: 4.94 in. (125.5 mm)
Depth: 2.25 in. (57.2 mm) (connected to BRAIN)
|WEIGHT||1.0 lb (454 g)|
|BRAIN MOUNTING||4x M4 captive mounting screws|
|BRAIN CONNECTIONS||Power delivery via Rear pogo connector (13-Pin)|
Communication via Rear I/O connector (4x40 Pin)
|CONNECTORS||DC IN (6-Pin 1B LEMO socket)|
3G-SDI output (75 _ BNC), 60 Hz max frame rate
HDMI 1.2 output (Type A socket), 60 Hz max frame rate
SYNC (Genlock IN / Timecode IN / Sync IN) (4-Pin 00B LEMO socket)
CTRL (Tally OUT / RS-232 Rx and Tx) (4-Pin 00B LEMO socket)
USB Power output (Type A socket), 1.5A
P-Tap Aux Power output (2-Pin), 3.0A
Stereo Analog Microphone input (3.5mm jack)
Stereo Headphone output (3.5mm jack)
|AUTO BOOT ON POWER||2-position slider switch|
|BATTERY COMPATIBILITY||RED BRICK|
|AUDIO||24-bit, 48 KHz, uncompressed, unbalanced mic level|
|OPERATING TEMPERATURE||0°C to 40°C (32°F to 104°F)|
|STORAGE TEMPERATURE||–20°C to 50°C (–4°F to 122°F)|
|OPERATING HUMIDITY||0% to 85%, non-condensing|
|STORAGE HUMIDITY||0% to 85%, non-condensing|
|FIRMWARE REQUIREMENT||Compatible with all DSMC2 firmware v6.2.17 or later.|
Tech specs reflect both current and projected information. Everything is subject to change.